To Connect The Remote Control To The Product With A Can Bus Cable; To Operate The Product With The Remote Control; To Do A Pairing Operation - Husqvarna PG 690 Manual Del Usuario

REV FWD
SPEED
0
POWER
0
ON
• Frequency: How fast the oscillation is.
In amplitude mode, the "OK" button starts the
frequency mode. The arrow keys let you adjust the
frequency value.
REV FWD
SPEED
0
POWER
0
ON
• In frequency mode, the "OK" button goes back to the
oscillation "ON"/"OFF" mode.
To operate the product with the remote
control
WARNING: Make sure that you can see the
product at all times when you operate it with
the remote control. The operation range of
the remote control makes it possible to move
the product also when you cannot see it.
Risk of injury and damage.

To do a pairing operation

The first time the remote control is used together with
the product, a pairing operation is necessary.
A pairing operation is also necessary if the remote
control is replaced or if you change remote controls
between products.
1. Make sure that the emergency stop buttons on the
control panel and on the remote control are
disengaged. Refer to
emergency stop button on the control panel on page
13 and To do a check of the of the emergency stop
button on the remote control on page 14 .
2. Connect the power cord and start the product.
1163 - 003 - 22.01.2020
Jan 05 12:45
FWD
REV
SPEED
0
POWER
0
0
m/s
4 4 1
OK
Jan 05 12:45
REV FWD
SPEED
0
POWER
0
0
m/s
4 4 1 OK
To do a check of the
3. Connect the CAN bus cable. Refer to
remote control to the product with a CAN bus cable
on page 29 .
4. Wait until the remote control is fully charged and the
main menu shows on the display.
5. Push the "OK" button to open the menu system.
6. Select "SETTINGS" and push the "OK" button.
Jan 05
SETTINGS
SERVICE
7. Use the arrow keys to go down to "PAIR RADIO"
and push the "OK" button.
8. A message on the display shows if the pairing
operation is done correctly. Do the procedure again
if the pairing operation is not done correctly.
To connect the remote control to the product
with a CAN bus cable
1. Put one end of the CAN bus cable in the connector
on the remote control.
To connect the
12:45
Jan 05
STOP WATCH
PAIR RADIO
RADIO CHANNEL
[ 3 ]
LANGUAGE
[ ENGLISH ]
12:45
29