Introduction; Technical Specifications - SPX LeakMaster 6525 Manual Del Operador

Introduction

Congratulations!
You are in possession of the most useful, yet simple to operate, Evaporative
Emissions (EVAP) system diagnostic tester available today. The LeakMaster's
versatile 12-volt design was specifically developed to diagnose vehicle EVAP
systems for leaks.
In addition, the LeakMaster will also find intake manifold system leaks, exhaust
system leaks, and under-dash vacuum system leaks. It will also diagnose many
other closed systems where you may suspect a leak, as well as pinpointing wind
and water leaks entering the vehicle's passenger compartment.
The LeakMaster's unique design allows the operator to confirm the integrity of
a system by utilizing a metered air system. If the tool has confirmed a leak in the
system being tested, it then introduces a non-toxic, diagnostic, marked vapor
(smoke) into the system. To locate the source of the leak, you simply look for the
smoke exiting the leak, or use a conventional ultraviolet (UV) lamp to view the
UV deposit left behind, which pinpoints the exact location of the leak.
The LeakMaster is shipped filled with a full charge of smoke-producing solution
that will last approximately 500 tests.
Height 23 in. (58.4 cm)
Width 18 in. (45.7)
Depth 9 in. (24.1 cm)
Weight 17 lbs. (7.6 kg)
Ship Weight 20 lb. (9.0 kg)
Power Supply 12V DC
Amperage Usage 15 amps
4

Technical Specifications

Supply Pressure
Supply Volume
Operating Temperature Range 45°F to 140°F (7.2°C to 60°C)
Supply Line
Power Supply Line
Remote Starter Cable
13.0 in. H O
2
15 liters per minute
12 feet (3.6 m)
12 feet (3.6 m)
12 feet (3.6 m)