Fitting The Auger - Stihl BT 131 Manual De Instrucciones

English
Disengaging the Auger Brake
B
Move the activating lever to
N
position B
Checking Operation of Auger Brake
The auger brake is subject to normal
wear and tear. Regularly check that it is
operating properly before you start work
and after releasing a trapped auger.
Before starting work and after releasing
a trapped auger
With the engine running at idle
N
speed, engage the auger brake and
then open the throttle wide for no
more than 3 seconds – the auger
must not rotate.
16
If the auger brake fails, have it repaired
immediately by your dealer – STIHL
recommends that this work be
performed by a STIHL servicing dealer.

Fitting the Auger

Shut off the engine and engage the
N
auger brake – see "Auger Brake".
Put the machine down.
N
2
1
3
Pull the retaining pin (1) out of the
N
auger's shank.
Push the auger (2) onto the drilling
N
spindle so that the holes (3) line up.
Push the retaining pin into the hole.
N
Spring clip on the retaining pin must
N
fit snugly around the auger's shank.
3
BT 131