Tabla de contenido
Publicidad
102
Maintenance
H90
Wheel acceleration was too slow, or braking was too
weak after a measuring run.
If the main shaft does not reach the required speed,
check that the brake is not activated or the weight of
the wheel is too great. In this case:
Release the brake.
Make sure that the shaft with the wheel clamped on it
can rotate freely.
Turn the wheel by hand then press the START key.
If the error cannot be eliminated, call the service team.
H91
Speed variations during measuring run. The brake
may be ON.
Release the brake.
Make sure that the shaft with the wheel clamped on it
can rotate freely.
Repeat the run.
7.2
After-sales service
Contact your area agent.
The company website provides information about the
Customer Assistance service around the world:
http://www.snapon-equipment.eu
Hotline (International) +49 8634 622-8996
Hotline (German): +49 8634 622-8994
Reception +49 8634 622-0
· Snap-on Equipment Germany ·
Konrad-Zuse-Straße,1 D-84579 Unterneukirchen
Publicidad
Tabla de contenido
