Help Information; Emergency Stop - Hofmann geodyna 7400 Manual Del Operador

2
32
3
4-15
4-18
4-19
Layout
4.8

Help information

Help information explains the current action and, in
the case of an error code, provides hints for remedy.
Display help information
— Press the HELP key (3, Fig.4-15).
The fi rst screen with help information appears, e. g. to
the screen RIM DATA INPUT (Fig. 4-18).
— Press the HELP key once more to display the next
screen with help information.
(if present)
The second screen with help information to the screen
RIM DATA INPUT (Fig. 4-19) appears.
Note
On pressing the HELP key in the last screen with help
information the display jumps to the fi rst screen again.
Quit help information
— Press the ESC key (2, Fig.4-15).

4.9 Emergency stop

Refer to Figure 4-15.
To perform an emergency stop:
• Select the STOP (5) key to apply the electronic
brake.
In the event of an emergency stop due to an unexpected
action by the unit, rethink the steps that were made:
Did the operator make an error or omit to do
something?
Correct the input and continue working. No special
procedure is required.
Did the unit do something unexpected?
• Read the relevant chapters again.
• Prepare the unit for a restart:
switch off the unit
switch on the unit again.
• Carefully repeat the commands with the manual
available.
• If the unit does not function correctly,
WARNING: PREVENT ANY FURTHER USE OF THE
UNIT.
• Call the service team immediately.