Preparing To Work - Hillyard Trident T30 SC PRO Manual De Uso

1
1 2
8
8
7
Before beginning to work, it is necessary to:
1. Make sure the recovery tank is empty. If this is not the case, empty it (read
2. Check that the quantity of detergent solution present in the solution tank is suitable for the type of work to be carried out. If this is not the
case, fill the solution tank (see
HDC)" or "FILLING THE DETERGENT CANISTER (VERSIONS WITH
machine (Fig.1).
3. Check the rubber squeegee blades are in good working condition. If they aren't, replace them (see
RUBBER BLADES").
4. Check that the condition of the brush is suitable for work; if this is not the case, replace it (see
(SCRUBBING VERSION)" or
5. Check that the machine is off; if this is not the case, turn the key (2) a quarter turn anti-clockwise (Fig.2) . Remove the key from the
instrument panel.
6. Grip the handle (3) on the right-hand side of the recovery tank (Fig.3) and turn the tank as far as it will go, until it reaches the maintenance
position.
7. Connect the main system connector (4) to the battery connector (5) (Fig.4).
ATTENTION: This process must be carried out by qualified personnel.
8. Grip the handle (3) on the right-hand side of the recovery tank and turn the tank until it reaches the work position.
9. Make sure the electronic brake is engaged. If this is not the case, turn the lever (6) in the direction of the arrow. The traction gearmotor is
located on the right-hand side of the machine (Fig.5).
10. Check the water tap is fully open - the water adjustment knob (7) must be turned fully in the direction shown by the arrow (Fig.6).
11. Make sure the solution tank drainage cap (8) is closed. If it isn't, close it (Fig.7).
12. Make sure the water filter cap (9) is closed. If it isn't, close it (Fig.8).
13. Make sure the cap of the recovery tank drainage tube (10) is closed. If it isn't, close it (Fig.9).
14. Make sure the vacuum tube (11) is correctly connected to the sleeve (12) in the squeegee body. If it isn't, connect it (Fig.10).
15. Make sure the vacuum motor filter (13) is correctly connected and is clean (Fig.11). If it isn't, clean it (see
TANK FILTERS").
16. Make sure the filter basin (14) is correctly connected and is clean (Fig.11). If it isn't, clean it (see
FILTERS").

PREPARING TO WORK

2
3
9
9
"FILLING THE SOLUTION TANK WITH
"REPLACING THE BRUSH HEAD BRUSH (SWEEPING
3 6
4
5
4
11
13
10
12
10
"EMPTYING THE RECOVERY
WATER" and "DETERGENT SOLUTION (VERSIONS WITHOUT
HDC)"). Check the level tube (1) in the rear left-hand part of the
"REPLACING THE BRUSH HEAD BRUSH
VERSION)").
18
7
5 6
14
11
TANK").
"REPLACING THE SQUEEGEE BODY
"CLEANING THE RECOVERY
"CLEANING THE RECOVERY TANK