Adjustment Of The Detergent Solution Flow; Regulating The Forward Speed; Reverse Gear; Extra Brush Head Pressure Function - Hillyard Trident T30 SC PRO Manual De Uso

ADJUSTMENT OF THE DETERGENT SOLUTION FLOW

To adjust the flow of detergent solution during work, proceed as follows:
1. During the first few working meters check that the amount of solution is sufficient to wet the floor, but not excessive to exit the splash guard.
2. If the amount of solution that comes out is not right, use the "+" and "-" buttons (11) on the control panel to adjust it (Fig.4).
N.B.: the flow of detergent solution onto the brush can be adjusted to four levels, from 0 to 3. The level can be seen with the symbol (12)
on the control display (Fig.3).
N.B.: If the flow is set to 0, there is no emission of detergent solution.

REGULATING THE FORWARD SPEED

To adjust the forward speed during work, proceed as follows:
During the first few metres, check that the forward speed is adequate to the grip conditions.
If the forward speed is not suitable, you can adjust this using the "+" and "-" buttons (13) on the control panel (Fig.4).
N.B.: The forward speed can be adjusted to three levels from 1 to 3. The level can be seen with the symbol (14) on the control display
(Fig. 3).
N.B.: the machine forward speed can also be adjusted by regulating the potentiometer in the control panel. To do this, press the dead
man's lever (4) (Fig.6) to the required degree. The more you press, the higher the speed (within the limits of the level selected
beforehand).

REVERSE GEAR

This machine is equipped with electronic traction control. To reverse, proceed as follows:
1. Lift the brush head body, press the "BRUSH HEAD COMMAND" button (7) on the control panel (Fig.4).
N.B.: As soon as the button (7) on the control panel is pressed, the green LED (8) ("BRUSH HEAD BODY WORK POSITION") will switch
off (Fig.4).
N.B.: if the brush head body is left in contact with the floor, the gearmotor will continue functioning but the solenoid valve will stop
dispensing detergent solution on the brush.
2. Raise the squeegee body and turn the squeegee control lever (3) in the direction of the arrow (Fig.8); the lever is located on the back of the
machine.
3. Press the "REVERSE ACTIVATION - DEACTIVATION" button (15) on the control handlebars (Fig.9).
N.B.: As soon as the button (15) on the control panel is pressed, the green LED (16) ("REVERSE ACTIVE") will turn on (Fig.4).
4. Activate the dead man's lever (4) underneath the control handlebars (Fig.6) to start moving the machine in reverse.
WARNING: the reverse speed is lower than the forward speed to comply with current health and safety standards. If the potentiometer is
adjusted while reversing, the adjustment of the forward speed will be automatically changed.
WARNING: It is impossible to reverse if the squeegee body touches the floor. In order to reverse, lift the squeegee body from the floor
using the relevant lever on the back of the machine.
N.B.: to disable reverse movement, press the button (15) on the control handlebars again.

EXTRA BRUSH HEAD PRESSURE FUNCTION

This machine can increase the pressure exerted on the brush during the work cycle. To do this:
1. Make sure the brush head body is in contact with the floor. If it isn't, press the "BRUSH HEAD CONTROL" button (7) on the control panel
(Fig.4).
N.B.: As soon as the button (7) on the control panel is pressed, the green LED (8) ("BRUSH HEAD BODY WORK POSITION") will switch
on (Fig.4).
2. Press the "EXTRA BRUSH HEAD PRESSURE" button (17) on the control panel (Fig.10).
22