Purpose And Content Of The Manual; Storing The Use And Maintenance Manual; On Consignment Of The Machine; Introductory Comment - Hillyard Trident T30 SC PRO Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PURPOSE AND CONTENT OF THE MANUAL

The aim of this manual is to provide customers with all the information needed to use the machine in the safest, most appropriate and most
autonomous way. This includes information concerning technical aspects, safety, operation, downtime, maintenance, spare parts and scrapping.
The operators and qualified technicians must carefully read the instructions in this manual before carrying out any operations on the machine. If
in doubt about the correct interpretation of instructions, contact your nearest Customer Service Centre to obtain the necessary clarifications.

STORING THE USE AND MAINTENANCE MANUAL

The Use and Maintenance Manual must be stored in its special pouch close to the machine, protected from liquids and anything else that could
compromise its legibility.

ON CONSIGNMENT OF THE MACHINE

When the machine is consigned to the customer, an immediate check must be performed to ensure all the material mentioned in the shipping
documents has been received, and also to check the machine has not suffered damage during transportation. If this is the case, the carrier
must ascertain the extent of the damage at once, informing our customer service office. It is only by prompt action of this type that the missing
material can be obtained, and compensation for damage successfully claimed.

INTRODUCTORY COMMENT

Any floor scrubbing machine can only work properly and effectively if used correctly and kept in full working order by performing the
maintenance operations described in the attached documentation. We therefore suggest you read this instruction booklet carefully and read it
again whenever difficulties arise while using the machine. If necessary, remember that our assistance service (organised in collaboration with
our dealers) is always available for advice or direct intervention.

IDENTIFICATION DATA

For technical assistance or to request replacement parts, always give the model, the version and the serial number (written on the relevant
plate).

TECHNICAL DESCRIPTION

The TRIDENT T30SC Pro and the TRIDENT T28SS Pro are floor scrubbing machines that can handle a wide variety of floors and types of dirt
using the mechanical action of two disc brushes and the chemical action of a water-detergent solution. As they advance, they collect the dirt
removed and the detergent solution not absorbed by the floor. The machine must only be used for this purpose.

INTENDED USE

This scrubbing machine was designed and built for the cleaning (scrubbing and drying) of smooth, hard flooring in the commercial, residential
and industrial sectors by a qualified operator in proven safety conditions. The scrubbing machine is not suitable for cleaning rugs or carpets. It
is only suitable for use in indoor (or at least covered) environments.
ATTENTION: the machine is not suitable for use in the rain, or under water jets.
ATTENTION: IT IS FORBIDDEN to use the machine for picking up dangerous dusts or inflammable liquids in places with an explosive
atmosphere. In addition, it is not suitable as a means of transport for people or objects.

SAFETY

Operator cooperation is paramount for accident prevention. No accident prevention programme can be effective without the full cooperation
of the person directly responsible for machine operation. The majority of occupational accidents that happen either in the workplace or whilst
moving are caused by failure to respect the most basic safety rules. An attentive, careful operator is most effective guarantee against accidents
and is fundamental in order to implement any prevention programme.

REGULATIONS

All references to forwards and backwards, front and rear, right and left indicated in this manual should be understood as referring to the operator
in the driving position, with his/her hands on the control handlebars.

TARGET GROUP

This manual is written both for operators and for qualified machine maintenance technicians. Operators must not perform operations that should
be carried out by qualified technicians. The manufacturer is not liable for damages resulting from failure to comply with this veto.

DISPOSAL

To dispose of the machine, take it to a demolition centre or an authorised collection centre. Before scrapping the machine,
it is necessary to remove and separate out the following materials, then send them to the appropriate collection centres in
accordance with the environmental hygiene regulations currently in force:
Brushes
Felt
Electric and electronic parts*
Batteries
Plastic parts (tanks and handlebars)
Metal parts (levers and frame)
(*) In particular, contact your distributor when scrapping electric and electronic parts.
8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Trident t28 ss pro

Tabla de contenido