Functionality Of The Neumann Logo - Neumann.Berlin KN 80 DSP Instrucciones De Manejo

Functionality of the Neumann logo

Action
Firmware activities
Loudspeaker is booting up
Loudspeaker boot up error
Loudspeaker firmware is being updated
Loudspeaker resetting to factory default settings
Everyday operation
Operating normally (dimmable via Neumann .
Control)
Loudspeaker in active system is solo'ed in
Neumann .Control
Loudspeaker system output level is dimmed or
muted (GUI button on Operate page)
Neumann .Control is saving changes to the
loudspeaker's memory (not Operate page
commands)
Protection and Standby
Protection system is activated (takes priority over
other indications)
Neumann.Control Alignment
Setup: Identify the loudspeaker
Guided Alignment: Loudspeaker is selected
Manual Alignment: Loudspeaker is selected
Precision Alignment: During countdown
Precision Alignment: Measuring the loudspeaker
Precision Alignment: Loudspeaker not being
measured
Logo indication
Solid red
Fast red flashing
Solid rosé
Rosé flutter flash
Solid white
Solid white
Solid rosé
Solid rosé
Red
Rosé pulses (2 Hz) + audible ID
tone
Rosé pulses (0 .5 Hz)
Solid rosé
10 rosé pulses (1 Hz)
Red to White crossfade + test
signal
White
KH 80 DSP | 10
EN