Cleaning And Maintaining The Kh 80 Dsp; Troubleshooting; Specifications - Neumann.Berlin KN 80 DSP Instrucciones De Manejo

Cleaning and maintaining the KH 80 DSP

CAUTION
Damage to the product caused by liquids!
Liquids entering the product can cause a short-circuit in the electronics and damage or even destroy the product .
Keep all liquids away from the product!
X
Before cleaning, disconnect the product from the mains power supply .
X
Use a soft, dry, and lint-free cloth to clean the product .
X

Troubleshooting

Problem
The Neumann logo is off, no sound
is heard from the KH 80 DSP
The Neumann logo is off or not
clearly visible, but sound is heard
from the KH 80 DSP
The KH 80 DSP is humming
The loudspeaker sounds very "thin"
in the bass . The low frequency
response is very low .
For further information, please refer to the "Questions & Answers" section on the product page at www .neumann .com .

Specifications

For a complete list of the product spefications please refer to the product page of the KH 80 DSP at www .neumann .com .
Product properties
Power supply
Power consumption (230 V / 100 V)
Dimensions (H x W x D)
Weight
Temperature
Operation and storage, unpacked
Transport and storage, packed in original packaging
Relative humidity
Operation and storage, unpacked
Transport and storage, packed in original packaging
Cause Solution
The KH 80 DSP main fuse Have the product checked by an
has blown . authorized Neumann service partner .
The Neumann logo is Switch on the Neumann logo
switched off or dimmed . and switch off the dimming (see
page 9) .
Incorrect wiring in the Check the cabling, especially if
audio cable and/or poor unbalanced cabling has been used - see
quality grounding in the the cable wiring digram on page 7 .
audio cable . Use gold plated connectors .
Set the output level of the KH 80 DSP as
low as possible and set the output level
of the audio source as high as possible,
without causing it to clip .
Incorrect wiring in the Check the cabling, especially if
audio cable or adapter . unbalanced cabling has been used - see
the cable wiring digram on page 7 .
100 to 240 V~, 50/60 Hz
Standby
Idle
Full output
233 x 154 x 194 mm (9 1/8" x 6" x 7 5/8")
3 .4 kg (7 lbs 8 oz)
+10 °C to +40 °C (+50 °F to +104 °F)
–25 °C to +60 °C (–13 °F to +140 °F)
max . 75 % (non-condensing)
max . 90 % (non-condensing)
<330 mW / <50 mW
9 W / 8 W
180 W
KH 80 DSP | 13
EN