Connecting Network Cables; Connecting/Disconnecting The Kh 80 Dsp To/From The Mains Power Supply; Power Source - Neumann.Berlin KN 80 DSP Instrucciones De Manejo

Connecting network cables

To use the extended functionality offered by the Neumann .Control software, the loudspeaker
must be connected to a standard network switch using a user supplied standard Ethernet cable
(Cat 5 or better) . The maximum length of the cable is 100 m .
Refer to the Neumann .Control software help for information about how to use loudspeakers in
a network .
RJ45
Connecting/disconnecting the KH 80 DSP to/from
the mains power supply
To connect the KH 80 DSP to the mains power supply:
Make sure that the on/off switch is set to "OFF" .
X
Connect the figure-8 connector of the supplied mains cable to the mains socket .
X

Power Source

Connect the mains plug of the mains cable to a suitable wall socket .
X
To disconnect the KH 80 DSP from the mains power supply:
Set the on/off switch to "OFF" .
X
Pull the mains plug out of the wall socket .
X
RJ45 RJ45
Network Switch
RJ45
EN
KH 80 DSP | 8