Configuring And Using The Kh 80 Dsp; Switching The Kh 80 Dsp On/Off - Neumann.Berlin KN 80 DSP Instrucciones De Manejo

Configuring and using the KH 80 DSP

Switching the KH 80 DSP on/off

On/O
Set the on/off switch to:
X
• "ON" to switch on the loudspeaker . The Neumann logo lights up solid red while the
DSP system boots up . After approximately 5 seconds it turns white indicating the loud-
speaker is ready to be used . If the logo brightness has been set to less than 100% in the
Neumann .Control software, it will be dimmed or off after the bootup phase is complete .
• "OFF" to switch off the loudspeaker . The Neumann logo switches to red for a short moment
and then goes off .
There is a five second delay before sound can be heard from the loudspeaker in order
to avoid noises (pops) from preceding equipment switched on at the same time . Con-
versely, switching off the loudspeaker immediately mutes the audio .
EN
KH 80 DSP | 9