Bevel Stop - Adjustment Procedure; Checking 45° Bevel Stop Setting - Bosch CM10GD Instrucciones De Funcionamiento Y Seguridad

2610051885.qxp_CM10GD 12/3/18 8:49 AM Page 27
▶ 45° Bevel Stop – Adjustment
Procedure
power source
assembly, adjustments or repairs.
▼ CHECKING 45° BEVEL STOP SETTING
1. Hold the saw head assembly down and push
in the head assembly lock pin (item 43 –
page 12) to keep the saw in the DOWN
position.
2. Slide the head assembly completely to the
back and engage the lock lever (item 27 –
page 12) by lifting up the finger tab.
3. Rotate the table to the 0° miter position.
4. Pull up the bevel lock lever to unlock. Move
the left sliding fence fully to the left.
5. Check the position of the bevel range
selector knob; it should be at the "0-45°
Left" position.
6. Tilt the
(counterclockwise) until it hits the 45° stop
– this is where the saw's 45° stop is set to
make a 45° left bevel cut.
7. Use a combination square to check that the
blade is 45° to the table. Remove the rule
blade from the combination square. Place
only the combination square's head on the
saw's table with its long flat side resting on
the table and its 45° side against the tilted
blade (see Figure 24).
Adjustments
To avoid possible injury,
disconnect plug from
before performing
saw assembly to the
Combination
Square Head
any
8. Check that only the saw blade's plate (not
teeth) is touching the square's 45° side. If
the saw blade's plate is not in full contact
with the square's head 45° side, follow the
"Adjusting 45° Bevel Stop" procedures.
left
27
Contacting
Blade
Contacting Table
Figure 24