Using The Mechanism Lock Lever; Mechanism Lock Lever; To Engage The Lock Lever; To Release The Lock Lever - Bosch CM10GD Instrucciones De Funcionamiento Y Seguridad

2610051885.qxp_CM10GD 12/3/18 8:49 AM Page 22
▶ Using the Mechanism Lock
Lever
power source
assembly, adjustments or repairs.

▼ MECHANISM LOCK LEVER

The lock lever (item 27 - page 12) is located
on the rear left side of the mechanism.
When engaged, it locks the system (item 35 –
page 12) in either the full forward or the full
back position and prevents movement while
transporting the saw. When held in the full
back position, the saw is more compact for
lifting and storage. The full back position is
often used while performing chop cuts.

▼ TO ENGAGE THE LOCK LEVER

With Saw in the Full Back Position –
1. Grasp the saw's main handle (item 3 - page
11) and push (slide) the head assembly
back as far as it goes. The upper housings
will be upright and closed.
2. Lift the tab on the lock lever to engage its
wedge into the joint area between the two
lower housings. Release the lock lever tab
and the main handle. The head assembly
will be locked in the full back position.
Lock
Lever Tab
To Engage in Back Position
Adjustments
To avoid possible injury,
disconnect plug from
before performing
Figure 13.
With Saw in the Full Forward Position –
1. Grasp the main handle (item 3 - page 11)
and pull (slide) the head assembly toward
you as far as it goes. The mechanism will be
fully extended.
any
2. Lift the tab on the lock lever to engage its
wedge into the joint area between the two
lower housings. Release the lock lever tab
and the main handle. The head assembly
will be locked in the full forward position.

▼ TO RELEASE THE LOCK LEVER

From Back or Forward Positions –
1. Grip the tab on the lock lever and press
down until its wedge comes out from
between the two lower housings. Release
your grip; the mechanism is now free to
slide forward and back.
Lock
Lever Tab
To Release in Front or Back Position
22
Lock
Lever Tab
Figure 14
Figure 15.