Cutting Grooves - Bosch CM10GD Instrucciones De Funcionamiento Y Seguridad

2610051885.qxp_CM10GD 12/3/18 8:49 AM Page 49

▶ Cutting Grooves

The depth stop adjustment is a feature used
when cutting grooves in the workpiece.
The depth adjustment is used to limit blade
depth to cut grooves.
NOTE: Read and understand all instructions
on page 23 in the Adjustments section on
"Setting Blade Depth for Non-Through Cuts
for Cutting Grooves."
NOTE: For best results, Bosch recommends
the use of a table saw with an optional dado
blade set for cutting grooves and non-through
cuts. In the event this is not available, the
feature described below is a convenient
alternative.
A groove should be cut as a slide cut.
1. For adjustment of groove depth, pull out
depth stop plate and rotate depth stop
screw. Rotating the depth stop screw
clockwise will raise saw blade and rotating
the screw counterclockwise will lower the
blade.
2. For minor adjustments, simply rotate the
depth stop screw to the desired location.
dry run with the saw Off by conducting a
simulated cutting cycle, and observe the
projected path of the saw blade. Keep hands
at least six (6) inches away from the
projected path of the saw blade.
Depth Stop
Plate
Figure 55. Cutting Grooves
Saw Operations
Be aware of the path of
the saw blade. Make a
Depth
Stop Screw
3. Cut the two outside grooves first.
Outside Grooves
Workpiece
Figure 56. Rough Cut Groove
4. After cutting a groove, shut saw "OFF" and
wait for blade to stop.
5. To remove material between cuts, move the
workpiece to the right or left. The saw must
come to a complete stop before moving
workpiece.
49