Bosch GCM18V-08 Instrucciones De Funcionamiento Y Seguridad página 28

2610051914.qxp_GCM18V-08 6/24/19 1:56 PM Page 28
Preparing for Saw Operations
▶ Workpiece Support
▼ CLAMPS
cannot be used. Support workpiece with your
hand outside the "No Hands" zone. Do not try to
cut short pieces that cannot be clamped and
cause your hand to be in the "No Hands" zone.
with the saw Off by conducting a simulated cutting
cycle, and observe the projected path of the saw
blade. Keep hands at least six (6) inches away from
the projected path of the saw blade.
There may be extreme
compound cuts where clamp
Be aware of the path of the
saw blade. Make a dry run
Fig. 29
Clamp Knob
Clamp
Clamp
Foot
Workpiece
28