Installation Conditions - BWT Avanti WF Instrucciones De Montaje

Installation conditions

Installation conditions Installation conditions
Installation conditions Installation conditions
Observe the local installation regulations, general
guidelines and the technical specifications.
Install the filter according to its nominal width in
cold water pipes of the same dimensions and be-
fore the equipment to be protected. Always pro-
vide stop valves.
Install the filter in a horizontal position in the water
pipe (observe flow direction arrows). A vertical
installation does not affect the function.
Attention: Attention: Attention: The installation site must be protected Attention: Attention:
against frost and must ensure the protection of
the filter against e.g. solvent vapours, fuel oil, lees,
chemicals of any kind, UV radiation and heat
sources above 40° C.
The plastic parts must be replaced even if there is
no visible damage after severe concussions and
shocks, e.g. due to the use of unsuitable tools or if
dropped on stone floors etc. (danger of bursting).
Attention: Attention: Attention: Attention: Attention: keep the plastic parts free from oil and
grease. Avoid extreme pressure impact (e.g. lock-
ing impact from solenoid valve behind the filter).
Installation Installation
Installation Installation Installation
See installation drawing on the left.
Install the filter and the stop valve in flow direction
in the water pipe (see flow direction arrows on top
section).
Star Star tup tup
Star Star Startup tup tup
Check the filter for proper installation.
The stop valves must not yet be opened. Check
the transparent cylinder (3 3 3 3 3 ) for proper fit and close
the discharging screw (4 4 4 4 4 ). Please do not use tools.
Manual fastening of the screw is sufficient.
Slowly open the stop valves before and after the
filter and deaerate the pipework at the bleeding
point closest to the filter (after the filter).
GB GB GB GB
GB
1 1 1 1 1 1 1 1 1 1