Setup; Packaging Content; Inserting The Batteries Into The Basic Unit; Inserting The Accumulator Into The Mobile Unit - HumanTechnik scalla3 combo Manual De Instrucciones

Setup

Packaging content

Please check whether all of the parts listed
in the following are included:
• Basic phone unit
• Phone receiver
• Receiver cable
• Phone cable
• Mobile unit
• Charging station for mobile unit
• 3 × 1.2V rechargeable batteries (type
«AAA") for the handset
• 2 × 7.5V plug charger
• Plate for photo target dial keys (in tele-
phone receiver)
• Instruction manual
• Warranty card
Please contact your dealer or directly the
manufacturer if parts are missing.

Inserting the batteries into the basic unit

Rechargeable batteries for the basic phone
unit are optional and not part of the delivery.
The phone can hold four 1.2 V rechargeab-
le batteries (type "AAA") for backup and full
function if the phone is without power from
the grid.
Please proceed as follows when inserting
the batteries:
1. Remove the battery compartment cover
underneath the phone.
2. Insert four 1.2 V rechargeable batteries
(type "AAA") into the battery compart-
ment. Ensure that the batteries are inser-
ted with the correct polarity!
3. Close the battery compartment cover.
Note: The power supply must be connected
for the background lighting of the display
and various special functions of the phone
to work (see "Connection of the phone").
50 English
Inserting the batteries into the mobile
unit
The wireless phone needs three 1.2 V accu-
mulator (type "AAA") to function.
Please proceed as follows when inserting
the rechargeable batteries:
1. Remove the battery compartment cover
underneath the wireless phone.
2. Insert three 1.2 V rechargeable batteries
(type "AAA") into the battery compart-
ment. Ensure that the batteries are inser-
ted with the correct polarity!
3. Close the battery compartment cover.

Connecting the phone

1. Plug the connector at the receiver cable
(spiral cable) into the receptacle at the
left side of the unit and into the telephone
receiver.
2. Plug one connector (RJ-11) of the phone
line cable into the receptacle »TEL-Sym«
(rear of the unit).
3. Plug the other connector (RJ-11) into the
country-specific adapter for your telepho-
ne line socket.
4. Plug the adapter into the telephone line
socket.
5. Plug the cable of the larger power supply
unit into the DC 7.5 receptacle. Plug the
power supply into a 230V electrical outlet.

Connecting the mobile charging station

1. Plug the cable of the smaller power sup-
ply unit into the DC 7.5 V receptacle. Plug
the power supply into a 230V electrical
outlet.
Caution!
Do not place the phone next to, for example,
TV sets, screens, fans, etc., to reduce the
risk of interference. Do not place the phone
in direct sunlight or near a heat source. Only
use the original phone cable or a compara-
ble cable with international configurations.