Switch To Adjust The Volume Reset; Use Of The Phone With A Hearing Aid; Muting; Hold - HumanTechnik scalla3 combo Manual De Instrucciones

You can also increase high or low frequen-
cies by using the sound control (slide switch
on the front, see figure 1).
Note:
The sound control is only functional if the
amplification is switched on.
Figure 1:
Sound control/volume adjustment

Switch to adjust the volume reset

Settings can be made on your phone so that
the volume will be reset to the basic settings
once the telephone receiver is hung up.
This means that persons, who do not need
amplification, can use the phone without
risks to their hearing due to a high volume.
For normal mode, the switch
of the equipment will be set to »Off«.
If you are the only user of the phone or if
you would like to deactivate the reset func-
tion, slide the switch
equipment to the »On« position. The adjus-
ted volume will not be reset if the telephone
receiver is hung up and your adjustments
are available for the next phone call.
on the back
on the back of the

Use of the phone with a hearing aid

You can use your phone with hearing aids,
assumed they are equipped with a T-coil.
For this purpose. place the selector switch
at your hearing aid to the "T" or "MT" po-
sition. Please ensure that the telephone re-
ceiver will be placed as close as possible to
your hearing aid during a phone call.

Muting

You can switch the microphone of your pho-
ne temporarily off during a call, which me-
ans that your conversational partner can no
longer hear you.
"Mute" will be displayed in the lower left
screen area of the display during a call. The
muting function will be activated when pres-
sing the left function key. The function will be
deactivated when pressing the key again.

Hold

You can put a phone call on hold.
"Hold" will be displayed in the lower right
screen area of the display during a call. The
hold function will be activated when pres-
sing the left function key. The function will be
deactivated when pressing the key again.

Insert dial break (PABX)

The dialing mode will be interrupted for a set
time by pressing the
Call back key (
R
This function is required to activate certain
T-NET performance features.
By pressing the
R
be disconnected for a certain time (100ms/
120ms/ 300ms/ 600ms) (see "Setup of the
call back time").
key.
/P
)
key, the phone line will
English 57