Threading The Bobbin Thread - Singer CE-200 Manual De Instrucciones

THREADING THE BOBBIN THREAD

1. Raise the needle to its highest position by rotating the hand
wheel toward you.
2. Remove the bobbin cover plate by pushing the release button
to the right while pushing the left corner of plate.
3. Insert the bobbin making sure the bobbin rotates counter-
clockwise.
4. Pull thread through the slot (A) and then to the left.
5. With a finger held gently on top of the bobbin, pull thread
through the slot (B) until you hear a clicking sound, and then
leave about 6" (15 cm) of thread.
6. Replace the bobbin cover plate onto the needle plate.
22
1
2
3
4
5
B
6
A