Operation Switches When Embroidery Unit Is Attached; Thread Tension Control - Singer CE-200 Manual De Instrucciones

Tabla de contenido

Publicidad

OPERATION SWITCHES WHEN
EMBROIDERY UNIT IS ATTACHED
OPERATION SWITCHES
START/STOP MACHINE
When start/stop switch is pushed, machine starts slowly, and
when the switch is pushed once more, the needle moves and
stops at its highest position.
NEEDLE UP/DOWN SWITCH
Embroidering can be advanced one stitch at a time (The hoop
moves.), after the embroidery data has been transferred.
To advance continuously, press and hold this switch.
REVERSE STITCH SWITCH
Embroidering can be reversed one stitch at a time (The hoop
moves.), after the embroidery data has been transferred.
To reverse continuously, press and hold this switch. Embroidering
can be reversed until the start of the embroidery data, after which
it will no longer move.
LED INDICATOR
Green light indicates machine is ready to start.
Red light indicates machine is operating.
Flashing red light indicates a problem or an error.
* Flashing for 2 - 3 seconds shows that an incorrect operation
was made.
* Continuous flashing indicates that machine malfunctions.

THREAD TENSION CONTROL

Set it at " E " for embroidery to loosen thread tension.
82
Needle up/down switch
Positionnement haut/bas
de l'aiguille
Interruptor agja arriba/abajo
Reverse stitch switch
Touche couture arrière
Interruptor de puntadas
hacia atrás
Start/stop switch
(For embroidery only)
Touche marche/arrêt
(Pour la broderie seulement)
Pulsador de comienzo/parada
(Sólo para bordado)
LED indicator
TÉMOIN A DIODE
Indicador LED

Publicidad

Tabla de contenido
loading

Tabla de contenido