b. For installation with 3-point-belt and ISOSAFE
35
1
2
1. Installation with ISOSAFE attachment is as
2. Place the child in the child restraint and check whether the shoulder belt
guides are at proper height.
3. Installation with 3-point-belt is show as
4. Correctly assembled 3-point-belt and ISOSAFE attachment is shown as
!
Make sure that both ISOSAFE connectors are securely attached to their
ISOFIX attachment anchor points. The colors of the indicators on both
ISOSAFE connectors should be completely green.
!
Check to make sure the child restraint is securely installed by pulling on
both ISOSAFE connectors.
!
Shoulder belt must pass through shoulder belt guide.
!
Waist belt must pass through lap belt guides.
!
The child restraint can not be used if the vehicle safety belt buckle
(female buckle end) is too long to anchor the child restraint securely.
!
Never use a vehicle waist-only belt across front of child.
!
Do not use shoulder belt loose or positioned under arm.
!
Do not use shoulder belt behind child's back.
!
Do not allow child to slide down in the child restraint in case of strangulation.
19
3
-
25
29
-
33
34
35
-1
35
-3
35
-2
35
Detach Soft Goods
see images
-
36
44
1. Press the red button to disengage the buckle.
!
To assemble soft goods, reverse the steps above.
36
38
37
39
20