Detach Soft Goods - Joie every stage fx Manual De Instrucciones

b. For installation with 3-point-belt and ISOFIX attachments
46
1
2
1. Installation with ISOFIX attachments is show as
2. Place the child in the child restraint and check whether the shoulder belt
guides are at proper height.
3. Installation with 3-point-belt is show as
4. Correctly assembled 3-point-belt and ISOFIX attachments is shown as
!
Make sure that both ISOFIX attachments connectors are securely attached
to their ISOFIX attachments anchor points. The colors of the indicators on
both ISOFIX attachments connectors should be completely green.
!
Check to make sure the child restraint is securely installed by pulling on the
both ISOFIX attachments connectors.
!
Shoulder belt must pass through shoulder belt guide.
!
Waist belt must pass through lap belt guidings.
!
The child restraint can not be used if the vehicle safety belt buckle
(female buckle end) is too long to anchor the child restraint securely.
!
Never use a vehicle waist-only belt across front of child.
!
Do not use shoulder belt loose or positioned under arm.
!
Do not use shoulder belt behind child's back.
!
Do not allow child to slide down in the child restraint in case of strangulation.
27
3
-
26 30
-
44 45
46
-1
46
-3
46
-2
46

Detach Soft Goods

see images
47
1. Press the red button to disengage
the buckle.
2. Remove the infant insert and
crotch strap.
3. Detach the elastic on the head
support, and then remove the head
support.
4. Detach the snaps on the seat pad,
pull the buckle to the back of seat
pad, and then remove the seat pad.
47
!
To assemble soft goods, reverse
the steps above.
47
28