Installation - Hoshizaki IM-240DNE Manual De Instalación

ENGLISH
Normal operating ambient temperature should be within 1°C to 40°C. Water connection is cold water only. Operation of the
icemaker, for extended periods, outside of these normal temperature ranges may affect production capacity.
Allow the clearance specified below for proper air circulation and ease of maintenance and/or service should they be required.
[Air-cooled model]
[Water-cooled model]
[Remote Air-cooled model]
In some high humidity environments, condensation may form inside the machine and drip onto the floor. Do not install where
the floor can be affected by water.

5. INSTALLATION

Incorrect installation can cause harm to people, animals or other items, for which the manufacturer cannot be held
responsible.
1) Lay the storage bin on its rear side carefully to prevent
damage. Secure the four adjustable legs (bin accessory)
into the four tapped holes on the underside of the bin.
2) Position the storage bin in the selected permanent position,
and level it in both the left-to-right and front-to-rear
directions.
3) Use the screws provided on the left or right side of the
storage bin to install the top kit.
4) Remove the icemaker panels. The rear panel is not required
to be removed for installation. See "3. UNPACKING".
5) Place the icemaker on the top of the storage bin. Be careful
not to damage the icemaker frame and the bin control
switch.
6) Secure the icemaker to the storage bin at the rear, by using
the mounting brackets and bolts provided.
7) Replace the icemaker panels in their correct position.
IMPORTANT
Top View
Rear
30cm
Left
15cm
ICEMAKER
Front
Top View
Rear
15cm
Left
15cm
ICEMAKER
Front
CAUTION
Side View
Right
50cm
Side View
Right Front
15cm
Bottom
Adjustable Leg
Top Kit
Bolt
4
Top
30cm
Front
30cm
ICEMAKER
Top
15cm
Rear
15cm
ICEMAKER
Adjustable Leg
Mounting
Bolt
Bracket
Mounting
Bracket
Rear
Icemaker
Bin