Safety Notices; Causes And Rectification Of Faults - CASO DESIGN EMGS 25 Manual Del Usuario

17.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

17.2 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program will not
start.
The turntable turns jerkily.
Food is not sufficiently
defrosted, warmed up or
cooked after preset time has
elapsed.
The device functions but the
cooking chamber lighting
does not work.
Abnormal noises can be
heard during operation of
microwave.
The time in the display field is
not correct.
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
Possible cause
Device door is not closed
Power plug is not plugged in Plug in mains plug!
Fuse is not activated
Dirt between the turntable
and the base of cooking
camber
Dirt on rolling ring
Cooking vessel too large
Incorrectly selected time or
power level
Defective cooking chamber
light.
Food is covered with
aluminium foil
The cookware contains
metal and sparks are being
created within the cooking
chamber
Power failure
Please note
Action
Close device door
Activate fuse
Remove dirt
Use different cooking
vessel
Re-set time and power
level
Repeat process
Have Service dept repair
cooking chamber light.
Remove aluminium foil
Observe information on
cookware!
Re-set time
74