About The Powerpack; Charging The Powerpack Battery - FujiFilm SonoSite PowerPack Manual Para El Usuario

About the PowerPack

Caution: To ensure proper operation of the
PowerPack and ultrasound system,
always have the system battery in
the ultrasound system.
The PowerPack contains a battery pack secured
within a housing that mounts on the Edge stand,
the V-Universal stand, or the H-Universal stand.
The PowerPack extends the system battery
running time up to 140% for any of the following
ultrasound systems:
• Edge ultrasound system
• M-Turbo ultrasound system
• S-Series ultrasound system
• NanoMaxx ultrasound system
The PowerPack powers the system only. If you
need to run AC-powered peripherals, connect the
stand to AC
power.
1
4
2
Figure 1 PowerPack mounted on stand:
1 Housing
2 PowerPack DC power cord
3 Power-supply DC power cord (from stand)
4 Indicators. See "Indicators"
2 About the PowerPack
5
3
6
on page 3.
5 Battery pack
6 DC input port, connected. See also
Figure 2 DC input port, disconnected
Charging the PowerPack
battery
A fully discharged PowerPack battery charges in
12 hours if the ultrasound system is turned off.
The system battery charges before the PowerPack
battery charges.
The PowerPack powers the system as well as
charges the system battery (if discharged). If the
PowerPack battery becomes depleted, the system
runs on the system battery.
If the stand is connected to AC power, the system
runs on AC power instead of battery power.
To charge the PowerPack battery
1 Make sure that the following are connected:
• Power supply DC power cord from the
stand (A) to the PowerPack. (See
"PowerPack cables and connectors"
page 4.)
• PowerPack DC power cord to the system
directly, to the NanoMaxx dock, or to the
mini-dock (depending on your system
and configuration).
2 Connect to AC power: Connect the system AC
power cord (K) to the stand and a wall outlet.
Figure 2.
on