Device Status Indicators - X-Rite i1Photo Pro UVcut Manual De Uso

Device Status Indicators

12
The i1Pro device is equipped with two device status indicators on its top housing. The
device status indicators provide feedback on the current status of the device and guide
you through the measurement process.
General device status:
off The device is either not connected to your computer, the software
is not running, or the latest software to control the device is not
installed on your computer. In the third case, the device can still
be used in compatibility mode with software supporting older
revisions of the i1Pro device.
solid white The device is connected but needs calibration.
pulsating white The device is connected and ready for measurement.
solid red The calibration of the device failed due to a hardware problem (see
troubleshooting section for further information).
To avoid interference of the device status indicators with the measurement process, the
device status indicators are switched off during measurement.
EN
13