Publicidad
Idiomas disponibles
Idiomas disponibles
Prior to commissioning
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Attention:
Do not use brushes which have reached
their wear limit. The wear limit is indicated
by the length of the red bristle. Do not use
worn or contaminated pads. Use original
TASKI brushes only. Failure to observe
these instructions may result in inade-
quate cleaning results or even floor dam-
age.
• The machine must be switched off (main switch).
• Position the brush under the brush unit.
• Plug the power supply cord into the mains socket.
• Switch on the machine (main switch).
Switch lights up
• Unlock the foot pedal and lower the
tool slowly.
• Briefly press the operating lever.
In this way the tool is centered and engaged.
Notice:
When the brush is down, gently moving
the machine back and forth can make the
clutch easier to engage.
56
Squeegee assembly
• The machine must be switched off (main switch).
• Position the squeegee (2) below the
squeegee holder (1).
1
1
2
2
• Press the foot pedal down until the
squeegee holder engages.
• Attach the suction hose to the con-
nector.
Filling the fresh water tank
Attention:
Max. permissible water temperature
60 °C/140 °F.
Diversey recommends using cold water
since hot water will adjust to the floor tem-
perature as soon as it is in contact with the
floor. Thus there are no advantages to us-
ing hot water.
• The machine must be switched off (main switch).
• Open the tank lid.
• Fill the fresh water tank with water.
Dosing:
Attention:
Wear gloves, goggles and appropriate
(protective) working clothes when han-
dling chemical products!
Notice:
Use chemical products recommended by
Diversey only and always observe the
product information.
Caution:
Using unsuitable products (e.g. products
containing chlorine, acids or solvents) may
cause harm to health and severe damage
to the machine.
Publicidad
Capítulos
