Control Panel; Touch-Screen; Main Menu Screen; Settings/User Options Screen - ACTEON QUAZ 17 l Manual De Uso

The waste water tank lasts at least 5 cycles.
Automatic emptying (requires installation)
Connect the tube to empty automatically (optional) at the back of the autoclave. Connect
the other side of the tube to the nearest drain and the autoclave will empty by means of
gravity without the user's intervention.
Do not reuse the waste water, it can affect autoclave's life and operation, as well as the
sterilisation parameters.

4. CONTROL PANEL

4.1. TOUCH-SCREEN

The touch-screen is located on the front of the QUAZ autoclave. It is used to set and
operate the machine.
When the autoclave is connected to the power supply, press the main switch on the
machine and the touch-screen will light up and display the 'QUAZ' welcome screen. Then it
will display the autoclave identification screen with the identification data (serial number)
and the data set by the user (name of the clinic,...), (see section 4.3.6.1.).
After a few seconds, the screen to open the door will be displayed if the door is closed, or
the main menu if the door is open.
The touch screen has an energy saving mode that will start 2 hours after the last operation.
Backlighting will be switched off but all the others autoclave's components will remain
activated. By touching the screen or closing the door, backlighting will be reactived.
Information set by the user +
QUAZ autoclave serial number and
10
software version

4.1.1 MAIN MENU SCREEN

Pressure inside
the chamber
Temperature inside the
chamber
Selection of the 'B' class
cycle at 134ºC 4
minutes, (currently
selected cycle)
Selection of the 'B' class
cycle at 134ºC 18
minutes
Selection of the 'B' class
cycle at 121ºC 15
minutes
Warning low level of
waste water in the tank
icon button to fill the
tank with distilled water
If the icon is flashing, the
distilled water tank is almost
empty; it needs to be filled up in
order to carry out a sterilisation
cycle (see section 3.5)

4.1.2 SETTINGS/USER OPTIONS SCREEN

4.2. SETTING DATE/TIME AND PROGRAMMED START SCREEN
The date and time are always visible at the top of the touch-screen. They can be changed
following these steps.
On the settings/user options screen (see section 4.1) press
Go to the screen to change the date and time
Door warning (Door not
Time Date
detected)
Door detected, press
on this icon to close
the door. If in 3
seconds the door has
not closed, it will open
Press on this icon to
open the door
Warning to empty the
waste water
+
If the icon is
flashing the waste
water tank is
almost full, it
needs to be
emptied in order to
carry out a
sterilisation cycle
(see section 3.5)
Go to settings/user
options screen
Go to the date/time
settings and
programmed start
screen
Go to test cycle
screen (Vacuum and
Bowie & Dick)
Go to maintenance
by a specialised
engineer screen.
Code required to
access the
maintenance screen
Go to the autoclave
personalisation
screen
Cycle counter
Exit the screen