Machine Features; Technical Data; Pictograms; Intended Use - Festool DOMINO DF 500 Q Manual De Instrucciones

Dowel jointer
Table of contents
1 Machine features ...................................... 12
2 Technical data .......................................... 12
3 Pictograms ................................................ 12
4 Intended use ............................................. 12
5 Safety instructions .................................... 12
6 Power supply and start-up ....................... 13
7 Machine settings ....................................... 13
8 Working with the machine ........................ 14
9 Maintenance and care ............................... 15
10 Accessories, tools ..................................... 15
11 Environment .............................................. 15
12 Example applications ................................ 16
13 Fault correction ......................................... 16
1

Machine features

[1-1] ON/OFF switch
[1-2] Rotary switch for Domino dowel-hole width
[1-3] Unlocking device for motor unit / guide
frame
[1-4] Auxiliary handle
[1-5] Clamping lever for angle guide
[1-6] Selection slide for material thickness
[1-7] Notch lever for Domino dowel-hole depth
[1-8] Notch lever lock
[2-1] Spindle lock
[2-2] Extraction nozzle
[2-3] Clamping lever for jointing height adjust-
ment
[2-4] Stop latch
The specifi ed illustrations can be found at the
beginning of the operating instructions.
2

Technical data

Power
Speed (no load)
Jointing depth, max.
Jointing width, max.
Jointing bit diameter, max.
Connecting thread of drive shaft
Weight (excluding cable)
Degree of protection
3

Pictograms

Note, Danger!
Wear ear protection!
Wear protective goggles!
420 W
25 500 min
-1
28 mm
23 mm + jointer bit
diameter
10 mm
M6 x 0.75
3.2 kg
/ II
Manual, read the instructions.
Wear a protective mask!
4

Intended use

The Domino dowel jointer is designed to produce
Domino dowelled joints in soft and hard wood, chip
board, plywood and fi bre boards. All applications
beyond this are regarded as unspecifi ed use.
The Domino dowel jointer is designed and ap-
proved for use by trained persons or specialists.
The user is liable for damage and injury
resulting from incorrect usage!
5

Safety instructions

5.1 General Safety Rules
WARNING! Read all safety warnings and
all instructions.
Failure to follow the warnings and instruc-
tions may result in electric shock, fi re and/or
serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
5.2 Tool-specifi c safety rules
- Mounting tools must be rated for at least the
speed marked on the tool. Mounting tools run-
ning over rated speed can fl y apart and cause
injury.
- Always use the guard. The guard protects the
operator from broken mounting tool fragments
and unintentional contact with the mounting
tool.
- Hold power tool by insulated gripping surfaces,
because the cutter may contact its own cord.
Cutting a "live" wire may make exposed metal
parts of the power tool "live" and could give the
operator an electric shock.
- The DF 500 Q must only be fi tted with the jointer
bits offered by Festool for this purpose. The
use of other jointer bits is prohibited due to the
increased risk of injury.
- Never work with blunt or damaged jointer bits.
Blunt or damaged jointer bits can lead to a loss
of control of the power tool.
- When the motor unit is released, it must move
back actuated by spring force so that the jointer
bit disappears completely in the protective
cover. If this does not happen, the machine must
be switched off immediately and repaired before
reuse.
13