Bed With 24 V External Power Supply; Installing Aria And Bella Side Rail - Invacare Medley Ergo Serie Manual Del Usuario

9.
Attach the mains wire in the strain relief that is attached to the
bed frame.
10. Before taking the bed into use, check that all parts run smoothly
and that no motor cables are hanging on the floor or being
squeezed while moving bed sections.

3.6.1 Bed with 24 V external power supply

1. Fasten the short cable A to the control box (a "click" must be
heard)
2. Attach the cable (as described in step 7 in the Wiring section).
Connect the short cable B to the transformer cable C.
3.
Connect the transformer 24 V D to the 230 V main socket.
4.

3.7 Installing Aria and Bella side rail

WARNING!
Risk of personal damage
There is a risk of entrapment or squeezing, while
assembling or disassembling the side rail.
– Follow instructions carefully.
– After assembly, check that the side rail has the correct
function.
The installation of Bella wooden side rail and Aria steel side rail is
identical.
Assembling the gliding system
1.
Push the pawl A from the backside, through the glider B and
make sure it locks with an audible click.
2. Do the same for all four pawls in each glider.
1556305-F
Attaching the gliding system and installing the side rail
1. Raise the bed to 1/3 of full height.
2.
Loosen the screw at the bottom of the guides on one of the
bed ends and push the glider halfway up into the guide until it
attaches with an audible click.
3.
Push the upper side rail onto the two upper pawls.
4.
In the other end of the side rail bar; push the two upper pawls
into the end of the bar.
5.
Push the attachment into the guide until it attaches with an
audible click (=properly engaged in the lower position).
6. Mount the lower side rail bar in both ends as in step 4.
Setup
9