Maintenance - baltur TBG 45 ME Manual De Instrucciones Para El Uso

BURNER
TBG 45ME 3 ÷31
TBG 60ME 6÷ 34
X= Combustion head-disk distance; adjust the distance X following
the indications below:
a) loosen screw 1
b) turn screw 2 to position the combustion head 3, referring to
index 4.
c) adjust the distance X between minimum and maximum
according the indications in the table.
The above adjustments are indicative only; position the
!
combustion head according to the characteristics of the
combustion chamber
COMBUSTION HEAD ADJUSTMENT DIAGRAM

MAINTENANCE

Analyse combustion gases and check that the emission values are
correct at least once a year, in compliance with current law.
Check the fuel filter: if it is dirty, replace it.
Check that all components of the combustion head are in good
condition, have not been deformed by high temperatures and con-
tain no impurities or deposits from the installation environment or
from poor combustion; check the efficiency of electrodes.
If it is necessary to clean the combustion head, take out its compo-
nents according to the procedure described below:
1) Loosen the screws 1 and remove the lid 2 (figure 1).
2) Make sure that mobile plate 3 is held in place by screw 4.
Once the maintenance operations have been completed, this
will make it possible to return the mixer assembly to the same
position it was in last time it was adjusted. Loosen screw 5,
which anchors the unit's forward movement rod to the mobile
plate (figure 2).
Value indicated by
X
index 4
0 ÷ 3.2
0 ÷ 3.2
0006081533_201403
3) After having loosened the nut (6) remove the blocking screw
(7) of the mixer unit (figure 3).
4) Completely remove the mixing unit (8) pulling it out in the
direction shown by arrow 9, after pulling the ignition and
ionisation cables 10 out of their electrodes (figure 4).
Having completed the maintenance works, refit the combustion
head, following in reverse order the operations described above,
after having checked the correct position of the ignition and ionisa-
tion electrodes (see 0002935682).
fig-2
14 / 22
fig. 1