Fitting Options; Mounting On The Wall; Fitting To The Floor - akkuteam VAS 5903 Instrucciones De Uso

Fitting options

Fitting to the
floor

Fitting to the floor

Mounting on the
wall

Mounting on the wall

370 mm
42 mm
(A)
(C)
(C)
(D)
Fit the charger to the floor using the
optional fitting brackets:
1.
2.
3.
4.
5.
Fit the charger to the wall using the optio-
(B)
nal wall bracket:
1.
2.
(A)
3.
4
Insert the fitting bracket into the left
and right-hand sides of the ventilation
grille on the charger's front panel, and
do the same on the rear panel
Mark the location of the holes on the
mounting surface (see diagram for
measurements)
Drill holes
Select the most suitable screws for
fastening the charger according to the
nature of the mounting surface
(diameter 5 mm)
Fasten charger to the mounting
surface using fitting brackets, each
with two screws
Place the charger onto the bracket
(insert wall bracket lug (A) into slot on
the plastic front panel (B))
Fasten the charger to the bracket
using the two screws supplied (C)
(diameter 3.5 x 9.5 mm)
NOTE! If fixing to the wall, please
note the weight of the charger.
Only fix to a wall that is suitable to
this purpose.
The bracket is fitted using suitable
dowels and screws at the cut-outs (D)