Charging / Refreshing Battery; Starting Charging - akkuteam VAS 5903 Instrucciones De Uso

Charging / refreshing battery

Starting charging

1.
2.
3.
After the battery capacity has been set, the charging current calculated from this is
shown on the display
4.
5.
6.
Important! If the battery voltage is < 1.0 V, the battery will not be automatically detected.
Charging must be started manually:
CAUTION! Risk of damage when attempting to charge a faulty battery. Before
charging, ensure that the battery to be charged is fully functional.
CAUTION! risk of damage to the vehicle electronics from refresh charging.
Before starting refresh charging, disconnect battery from vehicle power supply.
Select battery type and corresponding operating mode
Standard wet charging
Set the capacity of the battery to be loaded.
Connect (+) charging terminal to positive pole on battery
Connect (-) charging terminal to negative pole on the battery, or to vehicle body (e.g.
engine block) in the case of vehicle electrical systems.
Charger detects that the battery is connected, carries out a self test and starts
charging.
Self test
Refresh wet charging
E.g.: charging
8