Current Input Test; Starting Current Input Test; Starting Current Input Test Manually; General - akkuteam VAS 5903 Instrucciones De Uso

Current input test

General

The current input test mode is used to determine a battery's ability to accept charge.
the Volkswagen Group testing instructions for starter batteries and produced the follo-
wing results: „Fault", „Poor", „Charging" or „Tester does not start".
The current input test takes place as follows:
-
-
1.
Starting current
input test
2.
3.
4.
5.
6.
Starting current
1.
input test manually
2.
The current input test is used if a battery test has been carried out in accordance with
automatic current input test takes only a few minutes
after a pre-defined test time, the current input test ends and the results are shown
on the display
Select battery type and corresponding mode
Current input test
Set the capacity of the battery to be tested.
Connect (+) charging terminal to positive pole on battery
Connect (-) charging terminal to negative pole on the battery, or to vehicle body (e.g.
engine block) in the case of vehicle electrical systems
Charger detects that the battery is connected, carries out a self test and starts
current acceptance test.
Self test
Once the charging terminals are connected, press start/stop button for approx. 5 secs
WARNING! Risk of serious damage if the charging terminals are connected
incorrectly. The reverse polarity protection facility is inoperative if the current
input test is started manually (battery voltage < 1.5 V). Connect charging
terminals to correct poles and ensure proper electrical connection to vehicle
terminals.
Ensure charging terminals are connected to correct poles
Current input test
14