After Use; Removing The Respiratory Filter Or Lung Demand Valve; Removing The Facepiece; Maintenance - Dräger FPS 7000 Instrucciones De Uso

Maintenance

3.6

After use

3.6.1

Removing the respiratory filter or lung demand valve

RA Unscrew the respiratory filter or lung demand valve.

PE Unscrew the lung demand valve.

Unscrew the respiratory filter or press the buttons on the

ESA lung demand valve and at the same time pull the lung
demand valve out of the connector.
Press the button (Figure A3-25 on Page 3) and at the

P same time pull the lung demand valve out of the
connector.
3.6.2

Removing the facepiece

1. Push the adjuster buckles of the neck straps forward
with your thumb and loosen the straps (Figure E on
Full face
Page 3).
mask
2. Pull the full face mask away from your face and over
your head.
NOTICE
i i
To prevent damage, do not pull the connector.
Mask/helmet 1. Pull both mask/helmet adapters evenly to the rear,
combination then flip them away from the helmet.
with adapter 2. Remove the facepiece.
H61 (S-fix)
1. Pull both mask/helmet adapters slightly forward.
Mask/helmet 2. Press and hold the press studs of both mask/
combination helmet adapters.
with adapter 3. Pull both mask/helmet adapters evenly to the rear,
H62 (Q-fix) then flip them away from the helmet.
4. Remove the facepiece.
26
4 Maintenance
4.1 Recommended test and maintenance
intervals
The following information complies with DGUV-R 112-190 valid in
Germany. Observe national directives.
Type of work to be
performed
Check by the device user
Cleaning and disinfection
Visual inspection, function
and leak test
Replace exhalation
disc
Replace speech diaphragm
Replace O-ring of the speech
diaphragm
1) For full face masks in air-tight packaging, otherwise every 6 months
2) For full face masks in air-tight packaging: every 2 years
(approved by Dekra Exam)
X
1)
X X
2)
X X X
valve
Dräger FPS 7000
X
X
X