Cleaning And Disinfection - Dräger FPS 7000 Instrucciones De Uso

4.2

Cleaning and disinfection

Clean and disinfect the facepiece after every use.
WARNING
!
The mask body must be cleaned sufficiently thoroughly that
no residues of skin care products remain on the mask body.
Otherwise the elasticity in the sealing area can be lost and the
facepiece will no longer sit correctly.
CAUTION
!
Do not use solvents (e.g. acetone, alcohol) or cleaning agents
containing abrasive particles for cleaning and disinfection.
Use only the described procedures and the specified cleaning
agents and disinfectants. Other agents, doses and contact
times may cause damage to the product.
Do not clean or dry the inside of facepieces with a visor
marked "PCaf" with a cloth, since this may damage the
coating. After drying, these facepieces should be air-dried
unpacked for at least one day in a normal climate according
to DIN EN ISO 291, so that the coating can regenerate and
an optimum service life is achieved.
For information about suitable cleaning agents and
disinfectants and their specifications, refer to document
9100081 at www.draeger.com/IFU.
1. Remove accessories and clean separately.
2. Prepare a cleaning solution consisting of water and a cleaning
agent.
3. Clean all parts using a soft cloth with cleaning solution.
4. Thoroughly rinse all parts under running water.
5. Prepare a disinfectant bath consisting of water and a disinfectant.
6. Put all parts to be disinfected in the disinfectant bath.
7. Thoroughly rinse all parts under running water.
Dräger FPS 7000
8. Dry all parts in the air or in a drying cabinet (temperature: max.
60 °C). Do not expose to direct sunlight.
9. Fit the accessories.
Mask/helmet
combination
10. Apply a thin layer of Vaseline or Molykote
of the connector(Figure A3-18 on Page 3).
NOTICE
i i
The facepiece is also suitable for mechanical cleaning and
disinfection. Further information can be obtained from Dräger.
(approved by Dekra Exam)
Relubricate the sliding surfaces (ball joint, guide

plate) of the mask/helmet adapter with Voltalef
®
Molykote 111.
®
111 to the sealing surfaces
Maintenance
®
or
27