Setting the Lower Leg Length
After loosening the clamping screws on the left and right side of the footrest receiver, the footrest
can be adjusted in height (Fig. 10).
Starting from a lower leg length of 34 cm (13"), the footrest receiver at the anterior frame must
be set deeper.
Loosen and remove the holding screw (Fig. 11) and slide the footrest receiver to the second
bore hole. Retighten the screws at the footrest receiver. Repeat these modification steps at the
opposite side of the front frame.
Setting the Footrest deeper
The depth of the footrest can be adjusted to two positions (Fig. 12).
Setting the Seat Depth
First loosen and remove the screws (Fig. 13, pos. A) on both sides of the seat bottom. Afterwards,
carry out assembly at the desired seat depth (Fig. 14).
Danger!
After you have finished all adjustments, snugly re-tighten the screws that have been
loosened.
38
11
A
13
12
14