Grabrail And Grabrail Padding - Otto Bock Lisa Manual De Instrucciones

The lap belt runs over the front of the backrest upholstery and through the two eyelets (Fig. 35)
at the lower end of the backrest. The length of the lap belt is adjusted via the belt buckle.
The center strap prevents the lap belt from slipping upwards. The center strap is attached to
the corresponding loop at the seat bottom (Fig. 36) and adjusted in length via the buckle.
Note!
The center strap and lap belt must not be removed before folding the rehab folding buggy/
stroller.
5.8 (⊗) Grabrail and grabrail padding
To mount the grabrail, the receivers must be screwed to the seat tubes (Fig. 37).
Insert both ends of the grabrail into the receivers until the stop. The spring buttons must be
pressed down.
The arch of the grabrail must point towards the seat.
To remove the grabrail (Fig. 38), press down the spring buttons and keep them pressed.
Afterwards, pull the grabrail out of the receivers.
Slide the padding for the grabrail onto the rail.
35
37
36
38
45