Adjustment Of The Maximum Test Voltage; Error Messages - Chauvin Arnoux C.A 6505 Manual De Instrucciones

3.5. ADjUSTMENT OF THE MAxIMUM TEST vOLTAGE

The user can set a maximum generated voltage to prevent any accidental over-voltage tests being
conducted in error.
Set the switch to SET V.LOCK.
SET V.LOCK
SET V.LOCK
OFF
Change it using the and
You can then turn the switch to an insulation measurement setting and make measurements.
The maximum test voltage value is retained in a non-volatile memory. It will be displayed for a few
seconds on selection of an affected range.
For example, if the maximum voltage is 750 V, it will be applied and displayed on all settings of the
switch from 1000 V up.

3.6. ERROR MESSAGES

keys.
The insulation resistance is too low.
V
Check your connections, the + and - terminals
of the instrument may be short-circuited.

The maximum test voltage flashes.
V