Steering Friction Adjusting Screw (For Tiller Control Model); Trim Angle Adjusting Rod; Tilt Support Lever - Yamaha F2.5A Manual Del Propietário

2-13
EMU00108
STEERING FRICTION ADJUSTING
SCREW (for Tiller control model)
A friction device provides resistance to
steering movement. This is adjustable for
operator preference. An adjusting screw/bolt
is located on the swivel bracket.
EMU01296
Adjustment
Resistance Screw/Bolt
Increased Turn clockwise
Decreased Turn counterclockwise
WARNING
@
Do not over
screw/bolt. If there is too much resis-
tance, it may be difficult to steer, which
could result in an accident.
@
EMU01297

TRIM ANGLE ADJUSTING ROD

The position of the trim angle adjusting rod
determines the minimum trim angle of the
outboard motor in relation to the transom.
EMU00157

TILT SUPPORT LEVER

To keep the outboard motor in the tilted-up
position, lock the tilt support lever to the
clamp bracket.
GB
tighten the friction