Fitting And Removing The Skirt; Fitting The Skirt; Removing The Skirt; Mounting And Removing The Mowing Head - Stihl FSA 130 Manual De Instrucciones

English
6.3

Fitting and Removing the Skirt

6.3.1

Fitting the Skirt

► Switch off the trimmer and pull the connecting cable plug
out of the socket.
1
2
► Slide the guide slot in the skirt (2) onto the deflector (1) –
it must snap into position.
► Push the line limiting blade (3) into the slot in the skirt (2).
► Insert and tighten down the screw (4) firmly.
6.3.2

Removing the Skirt

► Switch off the trimmer and pull the connecting cable plug
out of the socket.
► Insert stop pin (2) into the hole in the skirt (1).
► Use the stop pin (2) to slide the skirt (1) off the deflector.
The line limiting blade (1) can be left on the skirt.
48
3
4
2
1
6.4

Mounting and Removing the Mowing Head

6.4.1

Mounting the Mowing Head

► Switch off the trimmer and pull the connecting cable plug
out of the socket.
► Place the thrust plate (2) on the shaft (3) so that its smaller
diameter faces up.
► Fit the mowing head (1) on the shaft (3) and turn it
counterclockwise.
► Insert the stop pin (4) in the bore as far as stop and hold
it depressed.
► Rotate the mowing head (1) counterclockwise until the
stop pin (4) engages in position.
The shaft is now blocked.
► Tighten down the mowing head (1) firmly by hand.
► Remove the stop pin (4).
6.4.2

Removing the Mowing Head

► Switch off the trimmer and pull the connecting cable plug
out of the socket.
► Insert the stop pin in the bore as far as stop and hold it
depressed.
► Rotate the mowing head (3) until the stop pin engages in
position.
The shaft is now blocked.
► Unscrew the mowing head clockwise.
► Remove the thrust plate.
► Remove stop pin.
6 Assembling the Trimmer
1
2
3
4
4
0458-726-9821-C
1