Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5. Turn the seat, and from below of the seat, take off the safety
buckle (F), by passing the retention plate through the seat base
slots (fig. 8.6).
6. Take out the safety buckle
8.2 Installing the seat
1. The seat must be in the number 1 recline position. (fig. 8.7).
Pull the lever
(I)
forward and adjust the angle of recline without
releasing the lever until the seat is in the 1 position.
2. Press the ISOFIX adjuster button
and pull them outward (fig. 8.8). Move each locking arm to check
that it is completely deployed.
3. Take the Top Tether
(P)
and pass it over the seat.
4. Place the child safety seat in the back seat of the vehicle facing in
the direction of travel.
5. Hold the safety seat with both hands and insert the two locking
(N)
arms
into the vehicle´s Isofix connectors until they fasten with
a click on both sides. The red button will change to green on both
sides (fig. 8.9).
6. Shake the seat to check that it is correctly anchored to the vehicle's
ISOFIX points.
IMPORTANT! The locking arms are only correctly fixed if both safety
buttons are green.
7. Push the safety seat towards the back using a firm, constant
pressure on both sides until it rests firmly against the vehicle seat
(fig. 8.10). If necessary, adjust the reclining of the vehicle´s seat
backrest to ensure that the child seat rests correctly.
8. Take the Top Tether and press the Top Tether
the strap.
9. Hook the safety clasp to the Top Tether anchor point recommended
in your vehicle instruction manual (fig. 8.11)
IMPORTANT! Make sure not to use the luggage clip instead
of the Top Tether anchor clip. Look for this symbol in your
vehicle.
34
(F)
and save it in the storage bag.
(M)
to unlock the Isofix arms
(P)
adjuster to stretch
10. To tighten the Top Tether, take up any slack by pulling the free
end of the belt through the Top Tether adjuster (fig. 8.12). The
Top Tether will be correctly tightened when the green tension
indicator extends 1 mm (fig. 8.13).
11. Place the child in the seat.
12.Pass the diagonal section of the belt through the diagonal belt
guide
over the guides
pass over the guide
13.Pass the vehicle belt and buckle the vehicle seat belt until you
(N)
hear a click (fig. 8.16).
IMPORTANT! The part of the abdominal belt should rest as low as
possible over the child's hips, on both sides.
9. INSTALLING THE CHILD SEAT FORWARD FACING
GROUP 2/3
For installing the child seat with Isoclick Fix
follow the steps described in chapter 8.2 "Installing the seat",
avoiding the points 8, 9 and 10.
10.INSTALLING THE CHILD SEAT FORWARD FACING
GROUP 2/3
For installing the child seat with 3 points belt, follow the steps 1,
4,11,12 and 13, described in chapter 8.2 "Installing the seat".
(C)
of the headrest. Pass the abdominal section of the belt
(J)
(fig. 8.15). Make sure the diagonal belt section
(J)
nearest to the vehicle belt buckle.
(ISOCLICK FIX
AND 3 POINTS BELT)
®
GROUP 2/3 only. From 4 years to 12 years
NOTICE
approx. (15-36 kg)
(3 POINTS BELT ONLY)
GROUP 2/3 only. From 4 years to 12 years
NOTICE
approx. (15-36 kg)
and 3 points belt,
®
35
Publicidad
Tabla de contenido
