Jøtul FS 166 - I 570 Manual De Instrucciones página 16

ENGLISH
Fig. 5
1. Dismount the insert's heat shield by unscrewing the upper
screw on both sides of the insert (fi g. 5 A). Loosen the
lower screws (fi g. 5 E) somewhat and pull the heat shield
upwards and then remove it.
2. Lay the insert carefully down on its back (you can protect
the fl oor with the wooden pallet and cardboard packaging).
Fig. 6
B
1. Mount the four cassette legs (Fig. 6 A).
2. Screw the foot screws (Fig. 6 B) through the foot. Adjust
lenght to approx. 15 mm (see Fig. 1 and Fig. 13).
3. Stand the product carefully up.
4. Reposition the previously removed heat shield (see Fig. 5).
16
A
Fig. 7
1. Unscrew the upper heat shield at the rear (Fig. 7 A). Turn it
upside down and screw it fi rmly in position using the same
screws it was fastened with before.
2. If top smoke outlet: Mount the heat shield for fl ue pipe
(Fig. 7 B).
Fig. 8 A
NB! Hole in fl oor for external air.
B
A