The weed broom and the front appliance carrier are op-
erated using the joystick.
1 Bolt for transport lock
2 Spring pin
A Operation
B Transport
Pull out the transport lock bolt.
Swivel the front appliance carrier to the right.
Insert the transport lock bolt into the operating position
and secure with spring cotter pin.
Lower the front appliance carrier until the broom touch-
es the ground.
Tighten the screw.
Tighten the locknut.
Start the motor.
Raise the front appliance carrier.
Roll (tilt at the side) the weed broom into the required
position, tilt it (forwards) and swivel it.
For cleaning work, switch on the working hydraulics for
the main PTO. The weed broom rotates.
Lower the front appliance carrier into the floating position.
Note:
Usually, the front appliance carrier is lowered into the
floating position. If you desire an increased cleaning per-
formance, the weed broom can be briefly pushed down.
Perform cleaning process.
8.1.6
Joystick function
1 Joystick
2 Front button
3 Function keys
A - blue
B - red
C - green
D - grey
56
The following are controlled with the joystick:
Implement frame
AUX 1 connection
AUX 2 connection
AUX connection, electrical 12 V
When selecting a float position, the corresponding dis-
play lights up.
8.1.6.1
Operations
Front power lifter (with float position)
Main switch, float
position (console)
Activate
Front power lifter (without float position)
Main switch, float
position (con-
sole)
Deactivate
Weed broom arm (with float position)
Main switch, float
position (con-
sole)
Activate
Press / lift the weed broom arm (without float position)
Main switch, float
position (con-
sole)
Deactivate
Swivel in / out the broom arm
Button to the
front (joystick)
---
Tilt the broom head (forwards)
Function button
Blue
Press and hold
Roll the broom head (tilt at the side)
Function button
Blue
---
8.1.7
Transport run
WARNING
Increased injury risk if working with unfavourably placed
weed broom. To minimise the injury risk, align the broom
as described below while you work.
Raise the front appliance carrier.
Tilt the broom forwards.
Swivel in the broom in a clockwise direction.
Insert the transport lock bolt into the transport position
and secure with spring cotter pin.
Mount the spray guard so that the broom is covered.
19
-
EN
Function button Joystick
Press the grey but-
---
ton (D)
Function button Joystick
---
to the front / to the
rear
Function button Joystick
Press the green
---
button (C)
Function button Joystick
Press and hold
move to the left /
right
Function button Joystick
---
move to the left /
right
Function button
Joystick
Red
---
move to the left /
right
Function button
Joystick
Red
Press and hold
move to the left /
right