Signal Flow - Roland SP-404SX Manual Del Usuario

Applying an effect while you sample
By pressing an effect button at this time, you can sample the sound processed by the effect.
MEMO
In this case, you can use the [CTRL 1] and [CTRL 2] knobs to adjust the effect settings. Because the [CTRL 3] knob is used
to adjust the digital input level, it cannot be used to adjust the effect settings.
6. Adjust the recording level
6-1. Produce sound on the device that's connected to the SP-404SX (if you're using a mic, vocalize into the
mic) .
6-2. Adjust the volume of the device (e .g ., portable music player) connected to the SP-404SX so that the
PEAK indicator lights occasionally .
The PEAK indicator should
light occasionally
6-3. If the display illumination lights red, the internal digital input level is excessive; turn the [CTRL 3] knob
toward the left until the display does not illuminate red .
If this lights red, the digital input level is
too high!

Signal flow

LINE IN jacks
MIC IN jack
Input Gain Analog signal
PEAK
Refer to p. 39
indicator
[MIC IN]
knob
Adjust so this
lights occasionally
Adjust the volume of your audio source (e.g.,
portable music player)
MEMO
If the volume of your device is not adjustable,
and the PEAK indicator stays lit, set the SP-
404SX's input gain to "-10 dB" as described on p. 39.
If you're using a mic, turn the [MIC
LEVEL] knob to adjust the level.
Turn the [CTRL 3] knob all the way to the right, and then turn it
toward the left until the red illumination no longer appears.
Digital signal
[CTRL 3]
knob
Effects
Resampling
Display illumination
If lit red, level
is too high!
19