Installing The Guard Plate Holders - Stihl MH 600 Manual De Instrucciones

● 1 Press release lever (height
adjustment) (1) downwards and hold.
● 2 Insert upper handlebar (2) at lower
handlebar (3).
● Position upper handlebar (2) at centre
detent (4). Release release lever
(height adjustment) (1) and allow upper
handlebar (2) to engage.
58
● Insert screw clamp (S) into the mount at
lower handlebar (1) from below.
● Secure upper handlebar (2) with screw
clamp (S) with washers (U) and
nuts (T).
● Tighten nuts (T) so that upper
handlebar (1) can be adjusted when
opening release lever (height
adjustment) (2). (Height of end of bolt
6,5 - 7,5 mm)

7.8 Installing the guard plate holders

Install the front guard plate holder
● Install front guard plate holders (N,O)
using bolt (W), washer (U) and nut (T).
Installing the rear guard plate holder
● Install rear guard plate holder (P) using
bolt (V), washer (U) and nut (T).
0478 404 9602 A - EN