Adjusting The Brake Spur; Starting The Engine - Stihl MH 600 Manual De Instrucciones

Transport wheel in working position:
● Detach spring clip (1) and pin (2) from
transport wheel (3).
● Fold up transport wheel (1) and secure
with pin (2) and spring clip (3).
● Check the transport wheel for secure
seating.
66

11.5 Adjusting the brake spur

The brake spur is used to regulate the
resistance and consequently the speed of
propulsion during tilling. The brake spur
can be adjusted in six stages for better
control.
Attention!
The brake spur can slip out. Hold
the brake spur during adjustment.
Adjusting the brake spur:
● Place the transport wheel in the working
position. ( 11.4)
Tilt the tiller forwards and make sure
that the machine is stable and safe.
● Unscrew bolt (1) so that brake spur (2)
can be adjusted.
● Detach pin (1) and spring clip (2).
● Move brake spur (3) to the desired
position and fasten once again with
pin (1) and spring clip (2).
● Clamp brake spur (1) using bolt (2).

11.6 Starting the engine

● Set the On/Off switch to 1.(
● Set the drive control lever to the 0
position.( 8.3)
0478 404 9602 A - EN
8.1)