Oris DM2 Instrucciones De Montaje página 2

GB
TRAILER HITCH FITTING INSTRUCTIONS
Type:
D- Value:
Vertical load:
Manufacturer:
Area of use:
EEC approval no.:
Official designation:
Note:
Fitting is to be executed in accordance with these
instructions.
When using the trailer hitch, always observe the manufac-
turer's data regarding trailer load and vertical load. The figures
stated for the trailer hitch must not be exceeded.
Formula for ascertainment of D-value:
Trailer mass [kg] x gross vehicle mass [kg]
Trailer mass [kg] + gross vehicle mass [kg]
The maximum permissible combined weight of vehicle and
trailer must not be exceeded. The maximum permissible
weight for the car-trailer combination is stated on the vehicle's
identification plate. Your Ford dealer will be
pleased to help you if required.
Before using the coupling device, the correct trailer
electrical kit must be installed (see service microfilm for
national requirements).
In the area of the contact surfaces, undersealing, anti-
corrosion wax and noise-deadening material must be
removed. If necessary, apply corrosion protection according
to Ford Service guidelines.
Jack the vehicle up. Remove the rear bumper and impact
absorber as instructed in the Workshop Manual.
The impact absorber is no longer required.
Release the rear mountings of the inner wheel-arch linings to
gain access to rear side members.
Align the side parts (B + C) of the hitch with the holes in the
rear side members and tighten the bolts (4x D) to finger tight-
ness.
When mounting the trailer hitch on the car body,
!
make sure that the bolts and threads are free of oil
and grease.
ORIS E 390/1
10 kN
75 kg
ORIS Fahrzeugteile
Hans Riehle GmbH,
D-71696 Möglingen
FORD C-MAX 2003 ➜
FORD Focus 3/5 door 06/2004 ➜
e1*94/20*1310
DM2/DA3,D33/DA3,D53
DA3 06/2004 ➜
9,81
x
1000
XXXX kg
Align the bumper supports (F + G) and the transverse bar (A)
with the holes in the side parts and tighten the bolts (4x D)
to finger tightness.
The weight of the transverse bar assures the correct position
of the side parts.
Tighten the bolts on the rear side members to the prescribed
torque first.
Then tighten the bolts on the transverse bar to the prescribed
torque.
Cut out the bumper in the central area as shown (N).
Replace the parts removed or loosened in accordance with
the Workshop Manual.
When the trailer is not in use, remove the ball neck and store
it beside the spare wheel as shown.
Instructions for using the removable ball neck are given in
the User's Manual of the Vehicle.
Operating notes:
The coupling ball must be kept clean and well greased (*).
= D [kN]
(*) Exception:
When stabilisers are in use which act on the coupling ball,
pro-ceed according to the instructions of the manufacturer
of the stabilisers. When stabilisers are in use, the coupling
ball must be inspected for wear at regular intervals.
As soon as a coupling ball diameter of 49.0 mm or smaller
has been been reached at any point, the towing device must
no longer be used in trailer operation; if necessary, the
towing device must be renewed.
The unladen weight of the vehicle will increase by appr. 22,0
kg following mounting of the towing device.