Integrated Descaling Programme - melitta CAFFEO SOLO&milk Manual De Instrucciones

Integrated descaling programme

Warning!
The descaling agent can cause skin
irritations
Comply with the safety instructions
and the dosing information specifi ed
on the descaling agent packaging.
The integrated descaling programme
(takes about 30 minutes) removes lime
residues inside the appliance. The symbol
for descaling
process.
The descaling programme should be
performed every 3 months, however, at
the latest when
the water hardness ", page 23).
Only use Melitta ®
• Switch off the appliance.
• Pull the supplied hose approx. 1 cm over
the steam pipe (Image J) to prevent the
spraying of liquids.
• Place the coffee grounds container to
the right of the appliance. The hose
should protrude into the coffee grounds
container as shown in Image J.
• Remove the water fi lter if necessary
(„Water hardness and fi lter", page 22).
• Press the and
simultaneously for ca. 3 seconds.
fl ashes, illuminates.
• Empty and reinsert the drip tray.
illuminates.
• Completely empty the water reservoir.
• Add the descaling agent to the water
reservoir according to the instructions on
the packaging.
• Insert the water reservoir.
• Press the button to start the
descaling programme (takes about 15
minutes).
BA_Solo_Milk_042015.indd 25 BA_Solo_Milk_042015.indd 25
fl ashes during the entire
illuminates („Setting
ANTI CALC.
buttons
When illuminates, proceed as follows:
• Ensure that the coffee grounds container
is placed under the steam pipe with the
hose.
• Turn the valve switch 11 clockwise until
the stop. is fl ashing. Water will fl ow
intermittently into the coffee grounds
container (takes about 10 minutes).
is then illuminated.
• Empty the drip tray and coffee grounds
container.
• Reinsert the drip tray and put the coffee
grounds container back under the steam
pipe.
• Rinse the water reservoir thoroughly
with clear water.
• Fill the water reservoir with tap water up
to the max. mark.
• Insert the water reservoir.
• Press the button to continue with the
descaling programme.
Water fl ows into the coffee grounds
container.
When illuminates, proceed as follows:
• Turn the valve switch 11
counterclockwise until the stop. Water
fl ows inside the appliance into the drip
tray.
• When is illuminated, empty the drip
tray and the coffee grounds container
and reinsert them. When
illuminated, the descaling programme is
fi nished.
• Insert the water fi lter if necessary
(„Water hardness and fi lter", page 22).
is fl ashing.
is
25
20.04.2015 21:01:01 20.04.2015 21:01:01